Omron CJ Series Operation Manual page 61

Item
CJ1W- Device setup
PRM21 DTM
Master setup
Bus parameter setup
Slave area setup
Monitoring functions
Additional Master functions
Support functions
Generic Support functions
Slave DTM
I/O configuration setup
Parameter setup
Group setting
Monitoring functions
Support functions
Note Note For more information on the GRT1-PRT DTM, refer to the SmartSlice GRT1- series GRT1-PRT PROFI-
BUS Communication Unit Operation Manual (Cat. No. W04E-EN-
CJ-series PROFIBUS Master Unit Operation Manual for NJ-series CPU Unit (W509)
1 Features and System Configuration
Specification
Device setup allows the user to:
• Select the PROFIBUS Master Unit's unit number.
• Configure the communication link between the PC and the Unit.
This function invokes the user interface of CX-Server.
• Test the Units communication link and read out the Unit's informa-
tion.
It allows enabling of Auto Addressing to facilitate I/O data mapping,
as well as defining the Unit's behavior in case of
• a network malfunction.
• CPU mode changes between PROGRAM and RUN mode.
The bus parameter setup allows the selection of baud rate and cal-
culation and editing of specific bus parameters.
The Slave area setup allows the user to define the I/O Data map-
ping of the I/O Data from each of the slave devices on to CPU
memory areas.
• Master status read out.
• Slave status and slave diagnostics read-out.
• Read out of the Unit's error log.
• Set remote slave address.
• Communication channels for PROFIBUS DP-V1 MSAC1 mes-
sages.
• Communication channels for PROFIBUS DP-V1 MSAC2 mes-
sages.
These functions are implemented as of Unit version 3.0.
• Context sensitive help functions.
• Multi-language support.
• Context sensitive help functions.
• Multi-language support.
The I/O configuration setup function allows:
• Selection of device address.
• Enable/disable watchdog.
• Overview of available I/O modules.
• Selection of I/O modules, including Addition, Insertion and
Removal of multiple modules.
The Parameter setup function:
• Setting of common as well as module dependent parameters.
• Setting of PROFIBUS DP Extension parameters.
• Setting of PROFIBUS DP-V1 dependent parameters.
The Group setup function allows definition of the group to which the
associated slave device will belong.
The Monitoring functions provides a display of
• Standard Slave diagnostics flags.
• Extended diagnostics messages.
• Context sensitive help functions.
• Multi-language support.
□
).
1
1-21