Omron CJ Series Operation Manual page 174

5 Operation
 CX-Server
Upon pressing the Configure button, CX-Server is launched and displays the CX-Server User Inter-
face as shown below
In order to configure CX-Server for communication with the Unit, perform the following procedure.
1
Select the type of CPU to which the Unit is attached, from the Device Type drop down selection
box.
2
Press the Settings button next to the CPU type selected. The CPU settings window (see figure
below) is displayed.
3
In this window make the proper adjustments if necessary. The selections made, must match the
physical configuration of the CPU system. When done, press the OK button.
4
Select the Network Type to be used as connection between the PC and the Unit. The available
options may include other CPU systems or Communication Units, which are setup to act as a
gateway. Refer to CX-Server Runtime User Manual (Cat. No. W391) for details on configuring
CX-Server.
Note 1 Only the direct connections between the PC and the CPU on which the Unit is attached are
considered. These include Ethernet and USB.
5-22 CJ-series PROFIBUS Master Unit Operation Manual for NJ-series CPU Unit (W509)