Table of Contents
Advertisement
Digital Feeder Operation and Maintenance Manual
Section 6 Getting started
Setting up the GBC Digital Feeder is quick and
easy. Follow the four steps ( loading the sheet stack,
adjusting the guides, making adjustments and setting the
controls ) to properly get started.
The laminator at this point should be webbed
and ready to run prior to setting up the feeder.
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the feeder. These items can
get caught in the machine and choke
you or you can be crushed.
INFORMATION
The feeder will only operate if the
Explorer 107 is running and the sheet
stack limit switch is engaged.
INFORMATION
All E-STOPS ( Feeder and Explorer 107 )
must be in the unlatched position.
© GBC Pro - Tech February 2000
WARNING
6.1 Loading the sheet stack
INFORMATION
A minimum sheet stack height of 3 in.
( 7.6 cm ) is required for loading.
a) Fold one sheet from the stack in half.
b) Unfold the sheet and place it back on the top
of the sheet stack.
Folded sheet
Getting started
Page 6 - 1
Advertisement
Table of Contents
Troubleshooting
