Control Panel Check - GBC DIGITAL FEEDER Operation & Maintenance Manual

Digital Feeder Operation and Maintenance Manual

4.10 Control panel check

The control panel should be checked to ensure
all controls function properly. Confirm the control panel
display reflects the input accordingly. The specific function
of each command is explained in Section 5 Operations.
Although RUN and VACUUM commands have
been pressed in previous steps, press them again in this
procedure to confirm the display changes.
RUN
a) Press RUN
ON
and the is illuminated.
ON
- Display shows
DIGITAL FEEDER
RUN ON
JOB 1
SHEET
GAP
© GBC Pro - Tech February 2000
. An audible beep sounds
R U N
ON OFF
VAC. OFF
TABLE STOP
7 28/32"
00/32"
G B C
b) Press RUN . An audible beep sounds
OFF
and the light extinguishes.
ON
R U N
ON OFF
- Display shows
DIGITAL FEEDER
RUN OFF
JOB 1 TABLE STOP
SHEET 7
GAP
G B C
VACUUM
a) Press VACUUM
ON
sounds and the
ON
VACUUM
ON
Installation
VAC. OFF
28/32"
00/32"
. An audible beep
is illuminated.
OFF
Page 4 - 23