Operations
- If an E-STOP on the Explorer 107 was
used . . .
c) Resolve the emergency situation.
d) Reset the E-STOP by rotating 1/4 turn
clockwise on the Explorer 107.
e) Press Motor Speed ON
feeder starts along with the Explorer 107.
MOTOR SPEED
e) Resume running.
Page 5 - 8
Unlatch
. The
O N
REVERSE
O N
O F F
Digital Feeder Operation and Maintenance Manual
5.3 Job programming
The job memory feature is very convenient if
the same parameters are required to perform various
feeding. This procedure will guide you step by step
through this feature.
a) Press JOB
desired numeric value.
JOB
M E M
b) Press JOB
to flash.
© GBC Pro - Tech February 2000
or JOB
to a
JOB
or
M E M
. The numeric value begins
MEM
JOB
M E M