Set Up - GBC DIGITAL FEEDER Operation & Maintenance Manual

Digital Feeder Operation and Maintenance Manual

4.6 Set up

Follow the set up procedure to properly separate
the conveyor from the feeder, preparing the laminator and
installing the conveyor.
Tools required
• Tape measure
• A second person
• A third person
• Side cutters
• #2 Phillips screw driver
Separating the conveyor
a) Set the front side of the feeder approximately
49 inches ( 124 cm ) from the front of the
Explorer 107 Laminator.
49 in.
( 124 cm )
© GBC Pro - Tech February 2000
b) Remove the accessory bag secured to the top
of the conveyor and set it aside for now.
Accessory bag contents:
• Thirteen ( 13 ) Metal balls
• One ( 1 ) Encoder cable
• One ( 1 ) pneumatic hose
c) Cut the two banding straps securing the
conveyor to the sheet table of the feeder. Refer
to Figure 4.6.1 Banding straps
Do not use a knife or other sharp objects
to remove the strapping / ties from around
the machine. You can cause
damage to the equipment.
Figure 4.6.1 Banding straps
Banding straps
Installation
CAUTION
Page 4 - 9