Section 5 Operations; Control Panel - GBC DIGITAL FEEDER Operation & Maintenance Manual

Digital Feeder Operation and Maintenance Manual

Section 5 Operations

Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the feeder. These items can
get caught in the machine and choke
you or you can be crushed.
This section discusses Control panel,
Emergency and Job programming.

5.1 Control Panel

The control panel for the Digital Feeder is
located on the control side of the machine. Refer to
Figure 5.1.1 Control panel
The control panel is separated into six
groupings. ( RUN, VACUUM, JOB, TABLE,
SHEET and GAP )
When POWER is pressed to " — ", the display
panel will indicate the last JOB number, SHEET size
and GAP entered before power was removed.
© GBC Pro - Tech February 2000
WARNING
Figure 5.1.1 Control panel location
D I G I T A L F E E D E R
RUN OFF
JOB
SHEET
GAP
R U N J O B
ON OFF
VACUUM
M E M
ON OFF
INFORMATION
Unit of measurement is set from the
factory for SAE. If metric is preferable,
contact your local service representative.
INFORMATION
Any command pressed will emit an
audible beep per press.
Operations
VAC. OFF
1 TABLE STOP
7 28/32"
00/32"
G B C
TABLE S H E E T
GAP
S T O P
Page 5 - 1