Burner Media Installation - Rinnai RF800 Operation & Installation Manual

BURNER MEDIA INSTALLATION

ONLY use the burner media supplied by the manufacturer in this appliance.
DO NOT BURN WOOD OR ANY OTHER MATERIAL IN THIS APPLIANCE.
WARNING
Logs, Coals and Granules
1. Fit the Rear Log Locator panel (supplied with the Logs and Coals) to the back of the burner using 4 screws.
2. Use a flat screw driver or similar to bend all of the log locating tags up wards until square to the burner.
3. Place one coal onto each of the 23
Locating Pins. The coals are to be
located centrally and at the same
angle as the tag. Push the coals
down until they are just sitting on the
burner.
4. Place, DO NOT POUR, all of the
supplied granules on the burner
and spread evenly across the entire
surface of the burner between the
coals.
Avoid pouring the media over the burner, as this can block the burner ports with the fine dust that
tends to settle in the bottom of the bags during shipping.
IMPORTANT
5. Place the remaining coals (a total of
31 should be used to get maximum
efficiency) and the supplied logs and
twigs over the first row of coals.
6. Once all the logs and coals are in
place, light the appliance and assess
the look of the flames. If there are
any areas that have very long streaky
flames then, using a pair of tongs,
move the top logs or coals to another
position until the flames are more
even across the whole burner.
Pebbles / Crystals (Crushed Glass), Where Applicable
1. DO NOT pile glass or pebbles over the top of the pilot assembly as this could affect it performance. It may be
possible to build the media up around the pilot to hide it slightly but always check that the pilot is operating at
its optimum when finished. (Refer to "Pilot Burner Performance" on page 20).
Avoid pouring the media over the burner, as this can block the burner ports with the fine dust that
tends to settle in the bottom of the bags during shipping.
IMPORTANT
Rinnai 21 RF800 OIM