Burn Media Installation; Adding The Glass And Vermiculite - Rinnai Ember Series Installation Manual

Burn media installation

Experience has shown that the majority of performance problems
are caused by burn media being installed incorrectly. Please take
the time to read and follow these instructions as malfunctioning
due to incorrect burn media placement is not covered by
warranty.
The Ember MUST NEVER be used with other burn media or burn
media that is damaged.
Ember 600/700 burn media sets - they are different and can't be interchanged
The Ember 600 and 700 burn media sets are different. The Ember 600 stone set has six less
stones and the log set is narrower and shorter—ensure you have the correct kit before starting.
Ember 600 log set
Back log
Front log
Ember 600 stone set - laid out in
the correct order
Positioning guide picture fixed to the unit will help
There should be a wonderful closeup picture secured to the fire to help you decipher what goes
where. Use this in conjunction with these instructions to help with the installation.
20 | Ember Installation Guide: 12890-B 02-18
Ember 700 log set
Front log
Back log
Ember 700 stone set - laid out in the correct
order

Adding the glass and vermiculite

This step is common to both models and both types of burn media. It requires
removing the upper burn media tray to access the mesh holding tray.
1. Unscrew the left and right tray screws to lift off the upper mesh holding tray.
2. Carefully empty the bags of vermiculite and glass into the mesh tray, blend together
and level out.
3. Put the upper tray back in place and re-tighten the screws.
1
2
2
Ember Installation Guide: 12890-B 02-18 | 21