Field & Wiring Harness; Circuit Board - Graco EM 5000 Instructions-Parts List Manual

NOTE: Refer to Fig. 28.
1. Remove the motor from the cart. See page 26.
2. Pull the plastic caps (B) off the wire screws (34) in
both places on the field (6). Loosen the screws and
release the wires (90).
6
Fig. 28
NOTE: Early series of sprayers had two circuit boards.
The other board should be removed from its
bracket and its wires spliced as follows and then
insulated and placed in the box.
Black to Yellow
Orange to nothing
1. Remove the cover (B) from the motor junction box
(A).
2. Remove the screws which secure the circuit board
mounting bracket. Remove the board (1a) and
bracket.
3. Remove the wires from the board, noting their origi-
nal locations.
4. Connect the wires to the new board in the same loca-
tion as the old board. Secure the board inside the
box.
5. Replace the box cover.
Field & Wiring Harness
1
12
2

Circuit Board

3. Loosen the four setscrews (12) holding the field (6)
to the clutch housing (2).
4. Pull out the field.
5. Skip ahead to Reassembly, page 29, Step 4..
90
B
34
Fig. 29
1
A
B
1a