Field & Wiring Harness; Clamp - Graco 231-576 Instructions-Parts List Manual

NOTE: Refer to Fig. 12.
1. Loosen the four setscrews (12) holding the field (6)
to the clutch housing (2).
2. Pull off the field.
3. Pull the plastic caps (B) off the wire screws (17) in
both places on the field. Loosen the screws and
release the wires (32).
4. Skip ahead to Reassembly, page 24, step 4. or
continue on page 21.
NOTE: A standard steering wheel puller and two
1/4–28 x 3 or 4 in. long screws are required to remove
the clamp.
NOTE: Refer to Fig. 13.
1. Loosen the two screws (16) on the clamp (3),
working through the slot at the bottom of the clutch
housing (2).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp (3). Tighten the screw
(C) until the clamp comes off.
3. Skip ahead to Reassembly, page 24, step 3., or
continue to the right.
Field & Wiring Harness

Clamp

12
2
6
B
17
Fig. 12
2
A
B
C
Torque to
125 ±10 in–lb
(14 ±1.1 N.m)
Fig. 13
32
03479
3
16
03480