Field & Wiring Harness; Clutch Housing - Graco GM 3000 Instructions-Parts List Manual

Field & Wiring Harness
NOTE: Refer to Fig. 18.
1.
Back out the four setscrews (58) holding the field
(53) to the clutch housing (1) approximately 3
turns.
2. Pull out the field. The field fits closely to the clutch
housing and must be removed carefully to prevent
jamming.
3. Pull the plastic caps (B)
off
the wire screws (79) in
both places on the field. Remove the screws and
remove the wire (A).
4. Skip ahead to Reassembly, page 29, Step 4 or
continue on page 28.
Fig. 18
Clamp
NOTE:
A standard steering wheel puller and two
the clamp.
1/4-28 x
3 or
4
in. long screws are required to remove
1
NOTE: Refer to Fig. 19.
A
1. Loosen the
two
screws (57) on the clamp (55), B
working through the slot at the bottom of the clutch
C
housing
(1).
2. Install
two
screws (B) of the tool (A) in two of the
threaded holes in the clamp (55). Tighten the
screw (C) until the clamp comes off.
3. Skip ahead to Reassembly, page 29, Step 2, or
continue below.
Fig. 19
05840
Clutch Housing
NOTE: Refer to Fig. 20.
A
CAUTION
If the clutch housing is removed from the engine a
special alignment tool is required to reinstall it.
1. Remove the four capscrews (83) and lockwashen
(84) which hold the clutch housing (1) to the en-
gine.
2. Remove the engine key (56).
3. Pull
off
the clutch housing (1).
4.
Skip ahead to Reassembly, page 29, Step 1.
28
308-620