Field And Wiring Harness; Alternator - Graco GM 5000 Instructions-Parts List Manual

210
See Fig 12 for a detail of
where 64 connects
Fig. 11
A
95
Fig. 13
Disassembly
1. Remove the engine. Loosen the knob (95). Grasp
the engine as shown in Fig. 13 and raise side A.
Slide the engine out of the channel (B).
2. Remove the screws (43) and belt guard (35).
Remove the belt (40). See Fig. 14.

Field and Wiring Harness

211
64
A
22
02702

Alternator

B
02689
NOTE: Refer to Fig. 11.
1. Pull the plastic caps (A) off the wire screws (22) in
both places on the field. Loosen the screws and
release the wires (64).
2. Loosen the four setscrews (211). Pull off the field
(210).
3. Skip ahead to Reassembly, page 24, Step 1 or
continue on page 22.
Fig. 12
Fig. 14
3. Remove the clutch housing (222) by removing
screws (100) from below the cart. See Fig. 14.
NOTE: This procedure is continued on page 23.
Ref 64
Ref 206
02700
35
43
40
222
100