Graco EM 5000 Instructions-Parts List Manual page 26

NOTE: The motor must be removed from the cart before
the Field, Clamp or Clutch Housing can be re-
moved. The Field, Clamp and Clutch Housing
must be removed in order to replace the motor.
1. Working under the mounting plate (A) of the cart, re-
move the screw (15), lockwasher (80) and washer
(33) which hold the clutch housing (2) to the cart. See
Fig. 27.
2. Remove the four locknuts (107) and lockwashers (9),
and then pull the flange screws (14) out of the base
of the motor (1). See Fig. 26 and Fig. 27.
3. Remove the pressure control cover. Disconnect the
four motor leads. Disconnect the + and – leads from
the rectifier (310). See Fig. 15, page 16.
4. Push the grommet (86A) out of the frame (A). Re-
move the screw, lockwasher and nut (62, 9, 61) and
the clamp (85). Push the grommet (86B) out of the
frame. See Fig. 26.
5. Fully loosen the nut of the connector (308). Pull the
wires carefully through the connector. See Fig. 26.
6. Carefully remove the motor and clutch housing as-
sembly. Place the motor on a work bench.
2
REF 90
Fig. 27
1
A
33
80
15
Motor
7. Remove the Field and Wiring Harness, Clamp and
Clutch Housing, as instructed on pages 26 and 27.
8. Skip ahead to Reassembly, page 29, Step 1..
A
86A
63
308
VIEW FROM UNDER ENGINE MOUNTING
Fig. 26
REF 86B
33,80,15
86B
90
62,9,62,85
62, 9, 107
14
66
9
107
1
87
94