Graco EM 5000 Instructions-Parts List Manual page 29

1. Connect the clutch housing (2) to the adapter plate
(48) using the screws (62) and lockwashers (9). In-
stall the clutch housing and adapter plate assembly
to the motor (1), using the screws (47) and lockwash-
ers (74)
2. Install the motor shaft key (13). See Fig. 33.
3
6
Fig. 33
3. Press the clamp (3) onto the motor shaft (A). Main-
tain the 50.55 mm (+/– 0.25 mm) dimension shown
in Fig. 33.
4. To check the dimension, place a rigid, straight steel
bar (B) across the face of the clutch housing (2). Use
an accurate measuring device to measure the dis-
tance between the bar and the face of the clamp. Ad-
just the clamp as necessary. Torque the two screws
(16) to 13–15 N.m.
5. Install the field (6) in the clutch housing (2). Working
through the slot in the clutch housing, connect the
wires of the harness (90) to the screws (34) in both
places on the field. Pull the plastic caps (C) up and
snap them over the screws. With the setscrew holes
in the field and the clutch housing (2) aligned, tighten
the setscrews (12) oppositely and evenly, to
2.9 to 3.4 N.m. See Fig. 33.
Reassembly
13
48
74
47
2
9
62
90
34
1
A
12
TORQUE TO
2.9 – 3.4 N.m
11,16
2
FACE OF
HOUSING
B
A
Fig. 34
50.55 mm
16
TORQUE TO
13 – 15 N.m