Installing The Camera To The Mounting Plate - Bosch VEZ-221-ECCE Installation Manual

AutoDome Easy II IP
12. Secure the mounting plate to the Surface Mount Junction
13. Skip to Section 4.1.4 Installing the Camera to the Mounting
4.1.4

Installing the Camera to the Mounting Plate

To install the camera to the mounting plate for a surface or
suspended ceiling, do the following (certain steps contain
additional information for outdoor installations):
1.
2.
3.
4.
Bosch Security Systems, Inc.
Box with the three (3) M4 – .7 x 8 Phillips pan head
machine screws.
Figure 4.8 Install the Mounting Plate
1 Junction Box Holes
2 Cable Hole (40 mm maximum); Crescent Shape
Plate, page 29, to continue the installation.
Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #2 Figure 4.3).
Attach grounding wire from unit to junction box.
Attach user supplied ground to junction box.
Connect the mating connectors with the flying leads to the
user supplied wiring (see Section 8 Preparing the Wiring,
page 63 for wiring information).
Installation Manual
Installing a Surface Mount | en
F.01U.164.576 | 2.0 | 2010.03
29