8
en | Installing a Recessed Mount
1.1.3
Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
2.
3.
4.
5.
6.
F.01U.168.034 | 3.0 | 2010.12
Loosen the single safety locking screw on the base of the
unit using the user-supplied T-10 Torx wrench.
Figure 1.4 Unlock Safety Locking Screw
Remove the screw from the Earth ground (
of the mounting bracket.
Attach a user-supplied ground wire to the Earth ground
(
) screw hole on the mounting bracket and secure with
the screw.
Attach the green grounding wire from the unit to the
grounded (
) screw hole on the mounting bracket using
the attached captive screw washer.
Route wires on the side of mounting plate with the
crescent shaped cut-out.
Connect the mating connectors (supplied in the accessory
kit) with the flying leads to the user supplied wiring.
Installation Manual
AutoDome Junior
)on the top
Bosch Security Systems, Inc.