Service; Self Help - Bosch Evolution HES7252U Use And Care Manual

Replacing an Oven Light

Service

Self Help

The Cooktop
Table 13: Cooktop Troubleshooting Chart
Cooktop Problem
Element cycles more than usual
A slight odor is noticeable
when an element is turned on
Cooktop controls will not turn
on
Scraper is not working prop-
erly.
English 36
3. After moving the hinge brackets back down into position, be sure to close and
open the door slowly to assure that it is correctly and securely in place.
4. Door should be straight, not crooked.
Each light assembly consists of a removable lens, a light bulb and a light socket
housing that is fixed in place.
WARNING
• Make sure the appliance and lights are cool and power to the appliance
has been turned off before replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
• The lenses (if equipped) must be in place when using the appliance.
• The lenses (if equipped) serve to protect the light bulb from breaking.
• The lenses (if equipped) are made of glass. Handle carefully to avoid
breaking. Broken glass could cause an injury.
• Light socket is live when door is open
1. Read the WARNING above.
2. Turn off power at the main power supply (fuse or breaker box).
3. Remove the lens by unscrewing it.
4. Remove the light bulb from its socket by unscrewing it.
5. Replace the bulb with a new 40 watt appliance bulb. Avoid touching the bulb
with fingers, as oils from hands can damage the bulb when it becomes hot.
6. Screw the lens back on.
7. Turn power back on at the main power supply (fuse or breaker box).
Use these suggestions before calling for service to avoid service charges.
Possible Causes and Suggested Solutions
• Pan base is warped and not making full contact with heating surface.
• Base diameter of pan is too small for the size of the element.
• Pan ingredients have boiled dry.
• Material of pan is a poor heat conductor; heat transfers too slowly
• This is normal with new cooktops and will disappear after several uses
• Range is not receiving power. Check the power source to see if a fuse has blown or
if the circuit breaker tripped. Check cord to see if it is inserted completely into outlet.
• Cooktop panel is locked. Press and hold PANEL LOCK until indicator light turns off.
• The scraper blade is dull. The scraper is packaged with single-edge, stainless steel
blades. Replace with a standard single-edge blade.