Bosch Evolution HES7252U Use And Care Manual page 20

Operation - Oven
Delaying the Start of a Timed Mode
To Check the Cooking Time and
Stop Time After a Delay Has Been
Set
Setting the Sabbath Feature
Using the Probe (some
models)
Setting the Probe
English 18
Note: Time required for the oven to reach temperature must be included in
the set cooking time.
5. Press TIME. TIMED BAKE appears.
6. Press TIME. SET BAKE TIME appears in the
display and minutes flash.
7. Set minutes. Press TIME.
8. Hours Flash. Set hours. Press START.
9. TIMED BAKE appears in display and the oven begins to preheat.
After cooking is complete, display flashes TIME COOK END and reminder beeps
will sound. Press OFF to clear.
1. Follow steps 1 through 5 above.
2. Turn knob until DELAYED BAKE appears.
3. Press Time. SET BAKE TIME appears in dis-
play and minutes flash.
4. Set minutes and then press TIME. Hours Flash.
5. Set hours and then press TIME. SET BAKE END appears in the display.
6. Press TIME.
7. Use knob to enter the time of day the oven will stop cooking or turn off.
8. Set hours and then press TIME.
9. Set minutes and then press TIME.
Note: The clock automatically calculates time of day at which cooking mode
starts and stops. The displayed cooking time counts down by the minute.
10. At the end of the programmed cooking time, the oven will automatically turn
off. Display will show TIME COOK END and reminder beeps will sound. Press
OFF to clear.
Note: Remove food from oven immediately after cycle has finished to prevent
overcooking. Food left in the oven will cook even after the cycle is complete.
1. Press Time.
2. Turn knob to BAKE END or BAKE TIME.
3. Press Time.
See "Set the Sabbath Feature" on page 13.
This section explains how to operate the probe. See "The Probe (some models)"
on page 24 for guidelines, tips and suggestions.
The probe can be used to determine the internal doneness or the "END" tempera-
ture of many foods, especially meats and poultry.
The temperature range for the probe is 135°F to 200°F (57°C to 93°C). Oven tem-
perature can be set for 100°F up to 450°F (38°C up to 232°C).
1. Prepare meat and place in roasting pan (or on rack in roasting pan as recipe
specifies). Insert the probe into the meat. See "Inserting the Probe" on
page 24 for detailed instructions. Make sure the probe is not touching gristle,
fat, bone, the roast rack or the pan.
Note: Do not connect to probe receptacle until probe tip is properly inserted into
meat.
2. Place roasting pan with meat in cold oven on recommended oven rack. Plug
probe into the probe receptacle. The probe symbol will appear in display.
Note: The probe temperature can only be set when the probe is installed in the
oven.
1: 20
350°
F
TIMED BAKE
HR:MIN
5: 00
400
o
PM
F
DELAYED BAKE
HR:MIN