Weber Summit Kamado S6 Owner's Manual page 32

GENERAL TROUBLESHOOTING
Problems
Burner does not ignite when you push in and
turn the burner control knob.
Burner does not ignite, or flame is low.
Burner flame pattern is erratic.
Burner burns with a yellow or orange flame, in
conjunction with the smell of gas.
Inside of lid appears to be "peeling."
(Resembles paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on
our website. Log onto www.weber.com.
Solutions
Be sure that there is gas flow to the burner by attempting to match light your burner. Refer to "BURNER
IGNITION - Lighting with a Match". If match lighting is successful, the problem lies in the ignition system.
Refer to "SNAP-JET GAS IGNITION SYSTEM OPERATION" in the "MAINTENANCE" section.
Be sure that wires are correctly inserted into terminals. Check that the black wire is connected to the red
terminal on the valve. Check that the white wire is connected to the ground terminal at screw. Refer to
"MAINTAINING THE IGNITION COMPONENTS" in the "MAINTENANCE" section.
LP fuel could be low or empty. Replace LP cartridge. Refer to "REMOVING THE CARTRIDGE".
Inspect burner tube for possible obstructions. Refer to the "MAINTENANCE" section.
The inside of the lid is aluminum. It is not painted. It cannot "peel". What you are seeing is baked-on grease
that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to "CLEANING
THE INSIDE OF THE GRILL" in the "MAINTENANCE" section.
Weber-Stephen Products LLC
www.weber.com
© 2020 Designed and engineered by Weber-Stephen Products LLC,
1415 S. Roselle Road, Palatine, Illinois 60067 USA.