Weber S-460TM Installation Manual

Weber S-460TM Installation Manual

Built-in lp gas grill

Advertisement

GAS GRILL
Built-In LP Gas Grill Installation Guide
S-460
S-660
YOU MUST READ THIS OWNER'S GUIDE
BEFORE OPERATING YOUR GAS GRILL
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or death,
or damage to property.
1. Do not store or use gasoline or other
flammable liquids or vapors in the vicinity of
this or any other appliance.
2. An LP cylinder not connected for use shall
not be stored in the vicinity of this or any
other appliance.
Tank Enclosure Installation - Pg 25
DANGER
WARNING:
#43267
WARNING: Follow all leak-check procedures
carefully in this manual prior to barbecue
operation. Do this even if the barbecue was
dealer-assembled.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
WARNING: Do not try to light this appliance
without reading the "Lighting Instructions"
section of this manual.
43267 US 08/06/08
LP

Advertisement

Table of Contents
loading

Summary of Contents for Weber S-460TM

  • Page 1 GAS GRILL Built-In LP Gas Grill Installation Guide S-460 ™ S-660 ™ YOU MUST READ THIS OWNER’S GUIDE BEFORE OPERATING YOUR GAS GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3.
  • Page 2 Do not use a flame to check for gas leaks. Combustible materials should never be within 24 (60.96cm) inches of the top, bottom, back or sides of your Weber barbecue. Do not put a barbecue cover or anything flammable on, or in the storage area under the barbecue.
  • Page 3: Built-In Cutout Dimensions

    Side Burner Opening Access for electric on left hand side * Clearance from any surface or structure is at least 24” (609.6mm) from the back and sides of the grill or side burner. WWW.WEBER.COM ® BUILT-IN CUTOUT DIMENSIONS BUILT-IN CUTOUT DIMENSIONS S-460™...
  • Page 4 PARTS LIST Left Door - 1 Right Door - 1 Warming Rack - 1 Right Enclosure Panel - 1 Left Enclosure Panel - 1 Front Vent Panel - 1 Rear Vent - 1 Corrugated Gas Line - 1 WWW.WEBER.COM ®...
  • Page 5 Left Front Vent Clip - 1 Rotisserie - 1 Rotisserie Fork - 4 Rotisserie Motor - 1 Rotisserie Bracket - 1 Handle - 2 WWW.WEBER.COM ® PARTS LIST Smoker - 1 Smoker Bar - 1 1/2 inch Bolts (¼-20 x 1/2 inch Bolt) - 10...
  • Page 6 ASSEMBLY Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as shown (left). WWW.WEBER.COM ®...
  • Page 7 ATTENTION! Do not fully tighten screws. Clips should slide freely when installed. WWW.WEBER.COM ® ASSEMBLY...
  • Page 8 ASSEMBLY Back WWW.WEBER.COM ®...
  • Page 9 ASSEMBLY WWW.WEBER.COM ®...
  • Page 10 Adjust the Front Vent to rest squarely on ground. ASSEMBLY ® Built-In frame assembly. CLE AR AN CES 24" (610 mm) Any Surface Grill Frame Note: For a countertop treatment: Recommended 19.1 mm (3/4˝ inch) overhang. Notch front edge for frame to fully slide in. WWW.WEBER.COM ®...
  • Page 11 S-460™ WWW.WEBER.COM ® ASSEMBLY ATTENTION! Before applying any silicone sealant make sure the cookbox is flush with the front of the grill frame. 1/4" (6.35 mm) Drill Bit Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island”...
  • Page 12 S-460™ ASSEMBLY BATTERY HOUSING WIRING BLACK WIRE GREEN WIRE RED WIRE RED WIRE WARNING: Make sure that all control knobs are turned to the OFF position before connecting the gas supply and operating the grill. WWW.WEBER.COM ®...
  • Page 13 WWW.WEBER.COM ® ASSEMBLY Requires 3 “D” alkaline batteries (Included). Use alkaline batteries only. Do not mix old and new batteries or different types of batteries (standard, alkaline or rechargeable). Note: Secure wire to side panel.
  • Page 14 S-460™ S-460™ ASSEMBLY S-660™ S-660™ WWW.WEBER.COM ®...
  • Page 15 S-460™ Match Holder WWW.WEBER.COM ® ASSEMBLY S-660™...
  • Page 16 ATTENTION! Before drilling any holes for the rear vent make sure the cookbox is flush with the front of the grill frame. ASSEMBLY 1/4" (6.35 mm) Drill Bit WWW.WEBER.COM ®...
  • Page 17 ASSEMBLY S-460™ S-660™ S-460 ™ S-660 ™ WWW.WEBER.COM ®...
  • Page 18 ASSEMBLY S-460 ™ S-660 ™ S-460™ S-660™ WWW.WEBER.COM ®...
  • Page 19 ASSEMBLY S-460™ S-660™ WWW.WEBER.COM ®...
  • Page 20 ASSEMBLY ™ S-460 ™ S-660 WWW.WEBER.COM ®...
  • Page 21 S-660 ™ ™ The Weber Grill Out Handle Light has a “Tilt Sensor”: Lid up - ON / Lid Closed - OFF. The power button (a) activates or deactivates the “Tilt Sensor.” For daytime use, deactivate the sensor by pressing power button (a).
  • Page 22 If you have any questions, contact Customer Service at 1-800-446-1071. TOLERANCES 4 3/4˝ +1/8˝(3.8mm) (120.65 mm) - 1/8˝(3.8mm) 6 1/4˝ +1/8˝(3.8mm) (158.8 mm) - 1/8˝(3.8mm) 2 1/2˝ +1/8˝(3.8mm) (63.5 mm) - 1/8˝(3.8mm) Plan View Left Side View Gas Inlet WWW.WEBER.COM ®...
  • Page 23 Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable. WWW.WEBER.COM ® GAS SUPPLY...
  • Page 24 If you do not follow the DANGER statements exactly, the Warranty on the Summit gas grill will be voided. DANGER DANGER ® Built-In WWW.WEBER.COM ®...
  • Page 25 BUILT-IN TANK ENCLOSURE INSTRUCTIONS OPERATING ® WARNING: Only use the Weber Tank Enclosure Kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. ® WARNING: Your Weber Tank Enclosure Kit shall not be used under an unprotected combustible roof or overhang.
  • Page 26 LP Tank Enclosure must be built from noncombustible materials only. NOTE: If you have questions on what materials are considered noncombustible, contact you local building supplier or fire department. ® LP Tank Enclosure Kit in a garage, WWW.WEBER.COM ®...
  • Page 27: Parts List

    PARTS LIST WWW.WEBER.COM ® PARTS LIST / ASSEMBLY Hose and regulator - 1 Tank stand - 1 Tank stand base - 1 Tank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2” bolt - 6 Cylinder glide - 2 1/2”...
  • Page 28 MOUNTING HARDWARE NOT INCLUDED. LP TANK ENCLOSURE GAS LINE LOCATIONS Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure. ASSEMBLY WWW.WEBER.COM ®...
  • Page 29 Typical tank cabinet or tank enclosure location Side View Top of Box Back of Box Corrugated Gas Line to Manifold 90° fitting 1/2” (12.7 mm) Flared Gasket Cap (Optional Side Burner) WWW.WEBER.COM ® GAS SUPPLY ® Built-In tank Enclosure Kit included...
  • Page 30 This may result in a fire or an explosion which can cause serious bodily injury or death, and damage to property. GAS SUPPLY WWW.WEBER.COM ®...
  • Page 31 NOTES...
  • Page 32 ©2009 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber, Kettle Silhouette , Genesis, Austria; Kettle Silhouette , Smokey Joe, Weber, Benelux; Kettle Silhouette , Smokey Joe, Weber, Compact Grill Configura- tion, Botswana;...

This manual is also suitable for:

S-660tmSummit s-460Summit s-660

Table of Contents