Software Update - Genie CE Series Operator's Manual Supplement

First Edition • Fifth Printing

Software Update

Checking the Application and
Bootloader Revisions from the
Ground Controls.
Verifying the machine application and
bootloader firmware revision levels must
be completed before updating the
software.
Not all machines will require a software
update.
1 Turn the key switch to ground controls.
2 Press and hold buttons 1 and 4. Pull out the
red Emergency Stop button to the on position.
3 Read and record the firmware revisions.
Bootloader Firmware:
Application Firmware:
Note: The application firmware revision is shown
under Current Firmware.
4 Press Escape. Press OK to exit bootloader
mode.
Part No. 1295772GT
Bootloader Firmware
Result: The Bootloader Firmware does not
need to be updated. Continue to Selecting the
Platform Option - Revision "F" or higher.
Result: The Bootloader Firmware must be
updated. Continue to Updating the Machine
Software - Revision "E" or lower.
Application Firmware
Result: For S65XC The Application Firmware
does not need to be updated. Continue to
Selecting the Platform Option - Revision "L" or
higher.
For S45XC The Application Firmware does not
need to be updated. Continue to Selecting the
Platform Option - Revision "1.7.2" or higher.
Result: For S65XC The Application Firmware
must be updated. Continue to Updating the
Machine Software - Revision "K" or lower.
For S45XC The Application Firmware must be
updated. Continue to Updating the Machine
Software - Revision "1.7.1" or lower.
Note: If a Firmware update is not required, a zero
load platform calibration must be performed. Refer
to Repair Procedure, How to Perform a Zero Load
Platform Calibration in the Service and Repair
manual that is appropriate for your machine.
4m Platform
Operator's Manual Supplement
Software Update
11