Oven Assembly; Packaging; Leg Attachment; Caster Attachment - Blodgett 1048 Installation Operation & Maintenance

PACKAGING

Before beginning assembly and installation of the
oven, check that all necessary components have
been received. In addition to the oven itself, legs,
the proper vent, and/or other accessories may be
required.
Single Sections
1048 with Steel Deck
Legs, regulator, set of flue plates, draft diverter
D
and steel deck are shipped in the oven.
Drafthood (when supplied) is packed separately.
D
1048 with Ultra Rokite Decks
Legs, regulator, set of flue plates and draft di-
D
verter are shipped in oven.
Ultra Rokite decks are packed in a separate car-
D
ton.
Drafthood (when supplied) is packed separately.
D
Double Sections
1048 with Steel Deck
Legs and bolts, regulator, set of flue plates and
D
steel deck are packed in the lower section.
Regulator, set of flue plates, draft diverter and
D
steel deck are packed in the upper section.
Crown angle leg frame is packed in a separate
D
carton.
Drafthood (when supplied) is packed in a sepa-
D
rate carton.
1048 with Ultra Rokite Decks
Legs and bolts, regulator, set of flue plates are
D
packed in the lower section.
Regulator, draft diverter and a set of flue plates
D
are packed in the upper section.
Ultra Rokite decks are packed in two separate
D
cartons.
Crown angle leg frame is packed in a separate
D
carton.
Drafthood (when supplied) is packed in a sepa-
D
rate carton.
Installation

LEG ATTACHMENT

1. Put the oven onto a genie lift with the bottom
of the oven down.
2. Each leg is attached by three bolts to the un-
derside of the oven base frame.

CASTER ATTACHMENT

1. Bolt supports to oven with 1/2-13 hex head
bolts (casters with brakes should be facing
front of oven.)
2. Carefully place oven onto the casters. (It will
be necessary to have several persons lift oven
off the pallet and set it onto the casters). En-
gage brakes on front casters.
NOTE: A fixed restraint must be provided if cast-
ers are used in conjunction with a flexible
connector for movable appliances. This
restraint must secure the oven to a non-
movable surface to eliminate stress on the
connector. If the oven is moved, the re-
straint must be reconnected after the oven
is returned to it's normal position.
5

Oven Assembly