Download Print this page

Blaupunkt Phoenix MP33 Operating And Installation Instructions page 15

Radio/cd

Advertisement

Available languages

Available languages

Handling the Remote Control Unit
Removing the battery insulation sheet
If an insulation sheet is attached to the remote control unit,
make sure to remove the insulation sheet before use. In this
case, the batteries will already be inside and can be used
immediately.
Insulation Sheet
Precautions on battery use
Always use lithium batteries (CR2025).
Inserting Batteries
1.
Push A in the direction of the arrow while holding B and
pull out.
2.
Confirm that the (+) (-) terminals are correctly aligned
and insert the lithium battery (CR2025).
3.
Push in the battery case until a "click" can be heard.
Lithium battery
Remote control
(CR2025)
unit rear surface
Battery case
A
E-14
phnx33_body
14
Operation
Operate while facing towards the sensor of the main unit.
CD mode
Radio mode
Seek tuning
Scan play
Preset scan**
Volume up/down
Seek tuning
Preset select
Track search
Band select
Cue/Review*
Travel store**
* Press and hold
** Press and hold for 2 seconds
Switching the Source
The mode will switch each time the SRC button is pressed.
Radio
CD
Direct Access
For direct access during radio mode, use the following op-
erations.
B
hold for
2 seconds
(Direct access mode)
(select)
Warning
Use the lithium batteries properly
(1) Never recharge, short circuit, disassemble, modify, heat
MP3 mode
or place in fire. This may result in fire, generation of heat
or explosion.
Scan play
(2) Place batteries out of reach of infants. If accidentally swal-
Folder scan**
lowed, consult a physician immediately.
(3) Use tape to insulate whenever disposing or storing batter-
ies. Contact with metals or other batteries may result in
fire or explosion.
Caution
Folder up
Properly align the battery (+) (-) terminals
Folder down
• Improper handling of batteries may cause fluid leakage or
explosions and may result in damage to the device or in-
Track search
jury.
Cue/Review*
Align the battery (+) (-) terminals correctly.
• Do not leave the remote control unit in high temperature
such as from direct sunlight. It results in the deformation of
the case, leakage of battery acid, and so on.
• Do not expose remote to water, damage may result.
or
,
(set)
03/4/22, 17:38

Advertisement

loading