4. Tighten the counternut (2) again.
5. Repeat steps 2 to 4 for the other feet.
The machine is aligned level.
7.4.2 Assembling the thread reel holder
Due to its height the thread reel holder is not installed when the machine
is delivered.
Important
The thread reel holder must be installed with the covers in place because
the covers can no longer be assembled when the thread reel holder is
installed.
Fig. 86: Assembling the thread reel holder
(1) - Thread reel holder
(2) - Thread reel holder bracket
To assemble the thread reel holder:
1. Insert the thread reel holder (1) into the hole in the thread reel holder
2. Align the thread guide (4) at right angles to the sewing arm.
3. Clamp the thread reel holder (1) using the clamping lever (3).
118
①
②
bracket (2).
③
(3) - Clamping bracket
(4) - Thread guide
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Setup
④