Table of Contents
Advertisement
Steps to be performed when operating the machine (sewing and
equipping)
Steps to be performed for service, maintenance, and installation
Steps to be performed via the software control panel
The individual steps are numbered:
1. First step
1.
2. Second step
2.
The steps must always be followed in the specified order.
...
Lists are marked by bullet points.
•
Result of performing an operation
Change to the machine or on the display/control panel.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Order
Specifies the work to be performed before or after a setting.
References
Reference to another section in these instructions.
Important warnings for the machine users are specially designated.
Safety
Since safety is of particular importance, hazard symbols, levels of danger
and their signal words are described separately in the chapter Safety
( p. 9).
If no other clear location information is used in a figure, indications of right
Location
information
or left are always from the user's point of view.
1.3 Other documents
The machine includes components from other manufacturers. Each man-
ufacturer has performed a hazard assessment for these purchased parts
and confirmed their design compliance with applicable European and na-
tional regulations. The proper use of the built-in components is described
in the corresponding manufacturer's instructions.
6
About these instructions
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Advertisement
Table of Contents
