Settings - Night Owl DP2 Series User Manual

A. Enable/Disable the Camera Light
Enabled by default on all channels. If LIGHT is selected, the camera light is enabled and
turns on when a Human Event is detected. You can customize your system if you choose
to turn off the lights for specific cameras.
B. Set the Recording Area
Use this feature to block out certain areas within the camera frame from recording.
Click SET AREA for a channel to set the Recording Area. Left-mouse click to create your
desired grid area:
– Area without the red or yellow grid is the area the DVR records.
– Area with the red or yellow grid is the area the DVR will NOT record.
By default, the DVR is set to record the full screen (no grid).
Set to record Full Screen
C. Set the Recording Sensitivity
Click the RECORDING SENSITIVITY dropdown to adjust the motion sensitivity needed to
trigger a recording. The higher the sensitivity, the more recordings. The sensitivity ranges
are low, medium, and high.
Enable the Timelapse, Detection, and Push Notification Settings
NOTE: The pre-defined scenarios are created for you to quickly enable the notification
functions that are used frequently.
To enable the timelapse, detection and push notification settings:
1. Select MENU > SCENARIO.
32
Set to not record any event Only right section of the screen
will record
DP2 / DP8 Series User's Manual