Step 5. Install The Cameras - Night Owl DP2 Series User Manual

Step 5.
Install the Cameras
IMPORTANT: Before you begin this step, if you have not already done so, ensure all cameras
Plan Your Installation
When planning your installation, keep the following pointers in mind:
Distance: The further the camera is from the DVR or monitor, the higher the chances of
signal degradation. Locate the camera's power supply as close to the camera as possible
when the distance exceeds 200 ft. as the power level will drop over extended distances,
resulting in video degradation.
Electrical Interference: Do NOT place the cameras near high voltage wires or other
sources of electrical interference. Electrical interference degrades the quality of the
signal.
Outside Elements: Avoid direct exposure to weather. Do not place the camera where
rain or snow will hit the lens directly. Do not place the camera so that the sun or bright
light shines directly into the lens. Your camera is weatherproof, but it will not work when
submerged in water. Ensure that all power and video connections are not directly exposed
to water and are protected from the elements.
Mounting Surface: Ensure your mounting surface holds at least four times the camera's
total weight.
Camera Angles: Use the Live View on your DVR to verify that your camera will be at an
ideal angle before permanently installing.
Install the Cameras
1. Use the holes in the base of each camera as a template to mark the screw positions on
the surface where you plan to mount the camera.
2. Using a drill bit slightly smaller than the included screw anchors, drill into the mounting
surface using the guide marks.
14
work before final installation.
DP2 / DP8 Series User's Manual