Table of Contents
Advertisement
Installing the Display Assembly
1. Connect the eDP cable to the display panel.
2. Tighten the screws to secure the display panel to the display assembly.
3. Tighten the screws to secure the display hinges to the display assembly.
4. Align and press in the display bezel to the display assembly.
5. Guide the WLAN cables through their tabs and then tighten the display hinge screws to secure the display assembly.
6. Install:
a)
system board
b)
palmrest assembly
c)
keyboard
d)
memory module
e)
hard drive
f)
access panel
g)
optical disk-drive
h)
battery
7. Follow the procedures in
Removing the Camera
1. Follow the procedures in
2. Remove:
a)
battery
b)
optical disk-drive
c)
access panel
d)
hard drive
e)
memory module
f)
keyboard
g)
palmrest assembly
h)
system board
i)
display assembly
3. Perform the following steps as shown in the illustration:
a) Disconnect the camera cable from the camera.
b) Release the retention tab from the display assembly [1].
c) Remove the camera from the display assembly [2].
After Working Inside Your
computer.
Before Working Inside Your
Computer.
Removing and Installing Components
23
Advertisement
Table of Contents
