Briggs & Stratton Fortress 10kW Installation And Operation Manua page 35

Antenna Placement
The wireless monitor includes an antenna that was
installed at the factory.
Before shipping, the magnetic-backed antenna was moved
to the side of the generator to prevent damage (A).
Before starting the wireless monitor, mount the antenna on
the top of the unit (B).
A
Wireless Monitor Operation
1. Remove battery access cover (C) on back of
monitor and install 2 AA batteries. (Observe correct
battery polarity which is embossed in the bottom of
the battery compartment). Replace battery access
cover.
2. The wireless monitor does not have an on/off
switch. When batteries are installed correctly, the
GENERATOR READY green LED light will flash
once every 7 seconds indicating the status of the
generator.
NOTICE The wireless monitor was linked to the generator
at the factory. Communication will begin upon the
installation of the batteries and the generator being placed
in AUTO mode. You may need to press System Update one
time.
generator ready
generator power
# of flashes
1 low battery voltage
2 low fluid level
3 under/over voltage
service needed
4 engine does not start
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
system update
generator systems
DEALER NAME
DEALER PHONE
B
service needed
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
C
35