Adjusting The Projected Image; Adjusting The Projection Angle; Correcting Picture Distortion - BenQ W7000 User Manual

Adjusting the projected image

Adjusting the projection angle

There are four adjuster feet on the bottom of the projector. These can be
used if necessary to change the projection angle. Screw the feet in or out
as appropriate to aim and level the projection angle.
If the screen and the projector are not perpendicular to each other, the
projected image becomes vertical trapezoidal. To correct this problem, see
on page 25 for details.

Correcting picture distortion

Keystoning occurs when the projector is not perpendicular to the screen and is where the projected
picture displays visible as a trapezoid shape like either of the following:
• Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
• No parallel sides.
To correct the picture's shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the
center of the lens level with the screen.
2. If the picture is stilled distorted, or the projector is unable to be positioned as described above, you
will need to manually correct the picture.
• Using the remote control or projector
i. Press one of the Arrow/Keystone keys on the remote control or
projector (Up
ii. See step iii below for further operation.
• Using the OSD menu
i. Press MENU and then press
highlighted.
ii. Press to highlight Keystone and press ENTER. The
keystone correction page displays.
iii. Press the key whose keystone icon is opposite to the shape of
the projected picture. Continue pressing the same key or press
the other keys until you are satisfied with the shape.
The values on the lower portion of the page change while
pressing. When the values reach their maximum or minimum
with repeated key presses, the picture's shape will stop changing.
You will not be able to change the picture further in that
direction.
/ , Down / ) to display the Keystone page.
/ until the Display menu is
Press
/
.
Press
/
.
Connecting with video equipment
"Correcting picture distortion"
Display
Aspect Ratio
Keystone
Position
Overscan Adjustment 0
PIP
PC & Component YPbPr Tuning
Frame Interpolation
3D
PC
Keystone
0
Back
Anamorphic
ENTER
Low
Back
25