Selecting An Input Source; Fine-Tuning The Image Size And Clarity - BenQ W7000 User Manual

Selecting an input source

The projector can be connected to multiple equipment at the same time.
When the projector is first turned on, it will attempt to reconnect with
the input source which was in use when the projector was last shut
down.
To select the video source:
• Using the remote control or projector
Press one of the Source keys on the remote control, or press SOURCE
on the projector repeatedly until your desired signal is selected.
• Using the OSD menu
1. Press MENU and then press /
highlighted.
2. Press to highlight Input Source and press ENTER. The source
selection bar displays.
3. Press / repeatedly until your desired signal is selected and press
ENTER.
Once detected, the selected source information will display on the
screen for seconds. If there are multiple pieces of equipment
connected to the projector, you can go back to the source selection
bar again to search for other signals.
• If you want the projector to automatically search for the signals,
select On in the System Setup > Auto Source Search menu.
• If you want to use the PIP function, see
image source simultaneously" on page 35

Fine-tuning the image size and clarity

1. Adjust the projected picture to the size
that you need using the zoom ring.
until the System Setup menu is
"Displaying more than one
for details.
2. Sharpen the picture by rotating the focus
ring.
System Setup
Language
Splash Screen
Projector Position
Auto Off
Sleep Timer
Menu Settings
Input Source
Auto Source Search
S-Video
HDMI 1
HDMI 2
Video
S-Video
Component 1
Component 2
PC
Connecting with video equipment
English
BenQ
Front Table
Disable
Disable
ENTER
On
Back
NOTE: When
automatically
searching for a
valid input source,
the projector
cycles through
the available
signals following
the sequence
from top to
bottom as the
source selection
bar shows.
21