Color Management - BenQ W7000 User Manual

Color Management

In most installation situations, color management will not be necessary, such as in classroom, meeting
room, or lounge room situations where lights remain on, or where building external windows allow
daylight into the room.
Only in permanent installations with controlled lighting levels such as boardrooms, lecture theaters, or
home theaters, should color management be considered. Color management provides fine color control
adjustment to allow for more accurate color reproduction, should you require it.
Proper color management can only be achieved under controlled and reproducible viewing conditions.
You will need to use a colorimeter (color light meter), and provide a set of suitable source images to
measure color reproduction. These tools are not provided with the projector, however, your projector
supplier should be able to provide you with suitable guidance, or even an experienced professional
installer.
The Color Management provides six sets (RGBCMY) of colors to be adjusted to favorite colors.
When you select each color, you can independently adjust its color range and saturation according to
your preference.
To adjust and store the settings:
1. In the Picture -- Advanced menu, highlight Color Management
and press ENTER. The Color Management page displays.
2. Highlight Primary Color and press
among Red, Green, Blue, Cyan, Magenta and Yellow.
3. Press to highlight Hue and press
the range will include colors consisted of more proportions of its two
adjacent colors.
Please refer to the illustration to the right for how the colors relate
to each other. For example, if you select Red and set its range at 0,
only pure red is selected. Increasing its range will include both the red
color close to yellow and red color close to magenta.
4. Press to highlight Gain and adjust its values to your preference by
pressing / . The contrast level of the primary color you select
will be affected. Every adjustment made will reflect to the image
immediately.
5. Press to highlight Saturation and adjust its values to your
preference by pressing
the image immediately.
For example, if you select Red and set its value at 0, only the
saturation of pure red will be affected.
Saturation is the amount of that color in a video picture. Lower
settings produce less saturated colors; a setting of "0" removes that
color from the image entirely. If the saturation is too high, that color will be overpowering and
unrealistic.
6. To leave and save the settings, press MENU once or EXIT twice.
/ to select a color from
/
to select its range. Increase in
/ . Every adjustment made will reflect to
Picture -- Advanced
Black Level
Clarity Control
Color Temperature
Color Temperature Fine Tuning
Gamma Selection
Brilliant Color
Color Management
Film Mode
3D Comb Filter
Dynamic Black
S-Video
Color Management
Primary Color
Hue
Gain
Saturation
Yellow
Red
Magenta
Blue
Connecting with video equipment
0 IRE
Normal
2.4
On
ENTER
On
On
On
Back
Red
15
15
15
Back
Green
Cyan
31