Utilizing The Password Function - BenQ W7000 User Manual

Utilizing the password function

For security purposes and to help prevent unauthorized use, the projector includes an option for setting
up password security. The password can be set through the On-Screen Display (OSD) menu. Once the
password is set and this function is selected, the projector is password-protected. Users who do not
know the correct password can not use the projector.
You will be inconvenienced if you activate the password functionality and subsequently forget the password.
Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in
a safe place for later recall.
Setting a password
Once a password has been set and activated, the projector cannot be used unless the correct password is
entered every time the projector is started.
1. Press MENU on the projector or remote control and then press
until the Advanced Setup menu is highlighted.
2. Press to highlight Password and press ENTER. The Password
page displays.
3. Highlight Change Password and press ENTER. The Input
Password page displays.
4. As the picture indicates, the four arrow keys ( ,
respectively represent 4 digits (1, 2, 3, 4). According to the password
you desire to set, press the arrow keys on the remote control or
projector to enter six digits for the password.
Confirm the new password by re-entering the new password.
Once the password is set, the OSD menu returns to the Password
page.
IMPORTANT: The digits being input will display as asterisks on-screen.
Write your selected password down here in this manual in advance or
right after the password is entered so that it is available to you should
you ever forget it.
Password: __ __ __ __ __ __
5. Highlight Power On Lock and then press
6. Confirm the current password.
7. To leave the OSD menu, press MENU.
If you forget the password
If the password function is activated, you will be asked to enter the six-
digit password every time you turn on the projector. If you enter the
wrong password, the password error message as pictured to the right
displays lasting for three seconds, and the Input Password page
follows. You can retry by entering another six-digit password, or if you
did not record the password in this manual, and you absolutely do not
remember it, you can use the password recall procedure. See
the password recall procedure" on page 24
If you enter an incorrect password 5 times in succession, the projector
will automatically shut down in a short time.
, , )
/ to select On.
"Entering
for details.
/
Advanced Setup
Lamp Settings
HDMI Settings
Baud Rate
Test Pattern
High Altitude Mode
Password
Key Lock
Reset All Settings
ISF
S-Video
Password
Change Password
Power On Lock
Input New Password
Password Error
Please try again.
Connecting with video equipment
115200
Off
ENTER
Off
Back
ENTER
Off
Back
Back
23