Replacing Hydrostatic Transmission Wire - Jonsered FR13 Workshop Manual

3
• Place the sealing collar on the axle, with the
metal spring inwards, and press it in carefully .
• Use the narrow end of a 1/4" extender to
carefully knock in the sealing collar until it
reaches the bottom of the axle housing. Only
knock on the steel cover.
Move the extender in a circle around the sealing
collar so that it is pressed in evenly all the way
around and tight against the axle.
• Remove the insulation tape from the axle and
repeat, as is necessary, the entire procedure for
the second axle.
• Replace the washer, spacing sleeve, key and
rear wheel on the axle. Fit the circlip that holds
the wheel and the plastic cover over the axle
end.
• Fill the transmission's oil container with SAE
10W30 oil until the oil level reaches the "MAX"-
marking.
• Bleed the transmission as directed in "Bleeding
of the hydrostatic transmission's oil system".
• Operate the ride-on mower and then check that
there is no oil leaking from the new axle sealing
collars.
• Check the oil level and top up if necessary after
test running.

Replacing hydrostatic transmission wire

Removal of hydrostatic transmission wire
1
Remove the frame plate by undoing the screws
(two on each side).
2
Loosen the hydrostatic transmission's front lock nut
a 1/4 turn and remove the lock spring.
3
Remove the hydrostatic transmission wire's front
clamp fixed inside the middle bracket.
Reparation instructions
37
English –