Jonsered FR13 Workshop Manual page 41

Reparation instructions
6
Draw the transmission wire along with the other
cabling. Place the wire at the bottom in the clamp,
under the articulated steering's bearing.
7
Put the wire in position and screw tight the casing
with the rear clamp.
8
Adjust the wire as directed in "Inspection and
adjustment of speed regulator". Connect the rear
linkage and fit the lock spring. Tighten the rear lock
nut for the linkage.
9
Check the setting of the neutral position contact.
40
– English
10
Fix the hydrostatic transmission wire with a cable
ties.
11
Refit the frame plate using the four screws.
~80