Removal/Installation Of Gear Box; Removal/Installation Of Hydrostatic; Transmission - Jonsered FR13 Workshop Manual

Reparation instructions

Removal/installation of gear box

FR 13
1
• Block-up the machine in front of the rear frame
and dismantle the rear wheels.
• Remove the cover from over the gear box.
2
• Release the tensioning wheel spring (1).
• Unfasten the clutch wire (2), and detach the belt
from the gear box pulley.
• Detach the gear and brake wires (3 and 4).
• Insert a garage jack under the gear box and
unscrew the gear box's five holder screws (5).
3
• Lower the garage jack and pull out the gear box.
• Installation of the gear box is carried out in the
reverse removing gear box order
• After installation, check that the clutch, brake
and gear wires are correctly adjusted (see
"Checking and adjusting brake wire", "Checking
and adjusting gear control" and "Checking and
adjusting freewheel clutch").
34
– English
Removing/installation of hydrostatic
transmission FRM 13 A
1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
2
• Release the tensioning wheel spring (1).
• Remove the fan (2), it is held by a circlip.
• Work off the drive belt (3).
• Remove the oil tank (4).
• Release the brake wire spring and remove the
brake wire from the brake lever (concealed under
the oil tank).
• Release the hydrostatic transmission link (5) in
the front ball joint.
• Remove the screw (6) holding the arm.
• Remove the freewheel clutch control (7) with its
spring.