Quality Rap 5.5 Document Stack Shingled - GBC FusionPunch II Service Manual

Quality RAP 5.5 Document Stack Shingled

Description
This RAP is used when the output stack is not
laying with each sheet within a set directly on
top of the sheet below it. This condition
causes the stack to slant from right to left
within the output tray.
Procedure
1. Send a job without tabs through the
GBC One-Sided Print Queue.
The document stack is still shingled.
Y N
Problem resolved.
Load paper in the Host Printer in the
opposite direction to correct for curl up/
curl down.
The document stack is still shingled.
Y N
Problem resolved. Instruct the
operator to watch for this condition
in the future.
Go to Step 2.
2. With no paper in the Stacker Tray,
observe the distance between the Stacker
Tapper and the Tray.
The Stacker Tappers are 1mm +/- 1/2 mm
from the Tray.
Y N
Perform ADJ 5.2 Stacker Tray Stop
Position and then ADJ 5.3 Tapper
Assembly.
Go to Step 3.
Quality RAP 5.5 Document Stack Shingled
3. Perform the Stacker Upper Switch
Checkout in RAP 5.1.
12/2003
3-10
GBC FusionPunch II Service Manual