Quality Rap 5.3 Sets Do Not Offset - GBC FusionPunch II Service Manual

Quality RAP 5.3 Sets Do Not Offset

Description
This RAP is used to troubleshoot Offsetting
problems in the Stacker.
Initial Actions
Open the Top Cover of the Stacker and
bypass the interlock. Run several sets to the
Punch and Stacker and observe the O-Ring
Drive assembly. Ensure that the O-Rings are
in good condition and that they are not
slipping or binding. Replace as required (PL
5.1C).
Procedure
1. Enter the Diagnostic Mode (GP1) and
using the information in the following
table, check the O-Ring Motor for proper
operation.
Use the left/right keys to underscore the
desired input.
Motor Diagnostic
O-Ring S1 OUTC8 Stack Oring
Motor O8 1100110011001100
The O-Ring Motor in the Stacker
energizes when the output is activated.
Y N
Go to Step 11.
Go to Step 2.
Quality RAP 5.3 Sets Do Not Offset
2. Enter the Diagnostic Mode (GP1) and
using the information in the following
table, check the sensors in the punch for
proper operation.
Use the left/right keys to underscore the
desired input.
Sensor Diagnostic
Entrance P INB4 Enter Sensor
I13 1100110011001100
Document P INB5 XportSensor1
Transport 1 I12 1100110011001100
Document P INB6 XportSensor2
Transport 2 I11 1100110011001100
Punch P INB7 Punch Sensor
I10 1100110011001100
Exit P INB8 Exit Sensor
I9 1100110011001100
Sequentially block and unblock the
sensor and observe the Control Panel for
a change in state (0 to 1, or 1 to 0).
There is a change in state when the
sensor is blocked and unblocked.
Y N
Go to RAP 4.2 Punch Jam Sensors.
Go to Step 3.
3. In the Diagnostics Mode, select End of
Set Beeper and set the value to 1. Run a
job from the host printer consisting of 5
sets. While the job is running, listen for
the beep tone at the end of each set.
12/2003
3-2
A beep is heard at the end of each set.
Y N
Go to RAP 6.2 Printer Connectivity.
Go to Step 4.
4. In Diagnostic Mode, set Offset Mode On
to a value 2. This will cause the Punch to
offset every 4 sheets of paper instead of
at the end of set signal.
Feed sheets from the Host Printer.
The Punch offsets every four sheets.
Y N
Go to Step 5.
Return the Offset Mode On value to 1
and go to Step 8.
5. With Offset Mode On set to 2, run the
Punch in Test Mode (GP2). Check the
following LEDs on the Stacker I/O-PWB:
L0B7 - Stacker Offset1 Output
L0B6 - Stacker Offset2 Output
LEDs L0B7 and L0B6 illuminate
alternately approximately once every
second.
Y N
Go to Step 6.
Go to Step 8.
GBC FusionPunch II Service Manual