Honda HHT25S Manual page 112

HHT25S•HHT35S
5. KWIK LOADER HEAD
REMOVAL/INSTALLATION
1. Align the gear case hole with the groove in the cover plate/
spacer A.
2. Insert a 4 mm hex tool or equivalent.
3. Hold the hex tool and turn the cutting-line head by hand in the
direction of the arrow.
4. Remove the threaded collar.
KWIK LOADER LINE
REMOVAL/INSTALLATION
1. To load, push the 20.32 cm (8 in) trimmer line into the housing
until 6 mm (0.25 in) minimum length is exposed in the inner
housing.
2. Do this equally for both sides.
The line will only move in one direction. Pull the trimmer line
through the inner housing to unload.
CUTTING ATTACHMENT / GEAR CASE
CUTTING LINE
WASHER
HEX TOOL
HOUSING
LINE
(push to load)
6 mm
(0.25 in) min.
THREADED
COLLAR
LOOSEN
6 mm
(0.25 in) min.
10-7