New Holland 200 Series Service Manual page 28

PARK BRAKE LAMP:
(7)
This Red lamp illuminates to indicate the
park brake is engaged.
Under normal conditions the park brake will
be set when:
• The PARK BRAKE button switch is ac-
tivated (located on the right-hand control
handle)
• The OPERATE button is activated
• The engine is shut off
• The engine is running and the restraint bar
is raised
• The operator leaves the seat
(8) ENGINE PREHEATING LAMP:
In cold climate starting conditions, after
turning the KEY switch to RUN, this yellow
engine pre-heating lamp will illuminate,
instructing the operator that incoming air is
being preconditioned for smoother starting.
The operator must wait until the lamp goes
out before attempting to start the engine.
(9) FUNCTION BUTTON
Use this, when in the SETUP menu, as the
"enter" data key
N : This button is used for user code lock
OTE
and unlock.
(10) FUNCTION BUTTON
Use this when in the SETUP menu, also
used to scroll within the setup menu.
N : This button is used for user code lock
OTE
and unlock.
(11) OPERATE
This button activates and deactivates the
hydraulic system when engine is running.
N : This button is used for user code lock
OTE
and unlock.
INTRODUCTION
47712044 29/04/2014
22
2
93109329A