New Holland 200 Series Service Manual page 33

PARK BRAKE LAMP:
(6)
This Red lamp illuminates to indicate the
park brake is engaged.
Under normal conditions the Park Brake will
be set when:
• The PARK BRAKE switch is activated
• The OPERATE button is activated
• The engine is shut off
• The engine is running and the seat belt is
not latched
• The operator leaves the seat
(7) ENGINE PREHEATING LAMP:
In cold climate starting conditions, after
turning the KEY switch to RUN, this yellow
Engine Pre-Heating Lamp will illuminate,
instructing the operator that incoming air is
being preconditioned for smoother starting.
The operator must wait until the lamp goes
out before attempting to start the engine.
(8) SYSTEM POWER:
Push for Start-up power and Engine shut
down power. Use this, when in the SETUP
menu, as the "enter" Data Key.
N : This button is used for user code lock
OTE
and unlock.
(9) START:
Push to actuate the starter motor and start
the engine. Use this when in the SETUP
menu, Also used to scroll within the setup
menu.
N : This button is used for user code lock
OTE
and unlock.
INTRODUCTION
47712044 29/04/2014
27
2
93109330