Alarms, Deviations, And Advisories; Clear Alarms; View Current Alarms; View Error Log - Graco 17G807 Operation And Parts

Alarms, Deviations, and Advisories

Alarms, Deviations, Deviations, and
Alarms, Alarms, Deviations,
Advisories Advisories Advisories
There are three types of errors that can occur:
Alarms, Deviations, and Advisories. Errors are
indicated by the flashing red LED as well as on the
display.
Alarms, indicated by
Alarms Alarms
therefore, the XP PressureTrak disables the air motor
and the alarm screen automatically displays.
Deviations Deviations Deviations, indicated by
not immediately.
Advisories, indicated by
Advisories Advisories
Therefore, if a deviation or advisory occur, the
system continues running and
on the run screen.
The following table shows the status of the front LED
for Alarms and Advisories.
Front LED LED Description
Front Front LED Description Description
OFF System is powered up and
monitoring pressure.
OFF In Circulation Mode or Manual
Bypass Mode.
OFF
A deviation exists.
Red Flash An alarm exists and the system
shuts down.

Clear Alarms

Alarms
Clear Clear Alarms
1. Turn the air valve to OFF.
2. Reduce the air pressure regulator to minimum.
3. Wait for the air pressure to drop.
4. Clear the cause of the error.
14
and
and
, require immediate attention;
, require attention, but
, do not require attention.
or is displayed
5. Press .
NOTE: NOTE: If the system has pressure when NOTE:
is pressed, the screen will change to indicate
this as the screens below. If these screens are
displayed, repeat steps 1 through 5.
XP XP PressureTrak XP PressureTrak PressureTrak
XP XP XP- - - hf hf hf PressureTrak PressureTrak PressureTrak
6. Turn the air valve to ON.
7. Increase the pressure to achieve the best pattern.
NOTE: NOTE: When trying to clear an error and the screen NOTE:
displays the "X", the unit did not retract the solenoid
and is in an 8 second delay period before an attempt
can be tried to retract the solenoid. Verify air
pressure has dropped.
View View Current View Current Alarms Current Alarms Alarms
To toggle the screens between the Alarm Information
Screen and the Run Alarm Active Screen, press
or .
View Error Error Log Log
View View Error Log
Setup Screen 3 is the error log screen. It displays the
most recent error on the top of the list with the past 20
errors below it. This screen displays a list of advisory
or alarm error codes and the time the error occurred
since the unit went to spray mode. The timer will
restart when the pressure falls and unit enters into
circulation mode, or when the timer rolls over 23:59.
3A3320D