Graco 17G807 Operation And Parts page 16

Alarms, Deviations, and Advisories
Code Icon Code Name
Code Code Icon Icon Code Code
Alarms Alarms Alarms
WJPX
WJPX WJPX Air Solenoid
Disconnected
P4AX
P4AX P4AX Pressure A
P4BX
P4BX P4BX Pressure B
BATT BATT BATT Low Battery
FUSE Blown Fuse
FUSE FUSE
Pressurized
pressure is not turned down. After shutting off the air pressure, press the pin until flush.
* Remote mix manifold applications only.
16
Name LED Status Status
Name LED LED Status
Flashing Red
Flashing Red
High
Flashing Red
High
Flashing Red
Flashing Red
System Flashing Red
System Pressurized Flashing Red Only the XP-hf will have these images if the air
Cause
Cause Cause
Broken cable.
Disconnected cable.
Damaged solenoid.
A pressure exceeded
maximum working
pressure set point.
A pressure exceeded
maximum working
pressure set point.
Too much restriction
on mix manifold B side
restriction.
Blockage in B line
downstream.
Battery is low.
Fuse is blown.
System is pressurized
when clearing an alarm.
Solution
Solution Solution
Replace cable.
Connect cable.
Replace solenoid.
Reduce air pressure to
motor or adjust setpoint.
Reduce air pressure to
motor or adjust setpoint.
Open down stream valve.
Reduce restriction to B
side on mix manifold.
Reduce downstream
restriction.
Clean mix manifold.
See Repair, page 18.
See Repair, page 18 for
information on how to
check the fuse.
Shut off air pressure and
wait for air pressure to
drop.
3A3320D