Graco 17G807 Operation And Parts page 11

Installation Installation for Installation for XP-hf for XP-hf XP-hf System
Xtreme XL XL Motor Motor
Xtreme Xtreme XL Motor
To reduce the risk of skin injection and shock, shut
down the XP Sprayer before installing your XP
PressureTrak. Follow the Shutdown
Relief procedures in the XP Sprayer operation
Relief Relief
manual.
The procedures in this section are specific to each
component of the XP PressureTrak. For sprayer
installation instructions, refer to the sprayer operation
manual.
Pressure Relief Relief Procedure
1. Perform Pressure Pressure Relief
XP-hf Operations sprayer manual 3A4381.
2. Remove the two top bolts (L) on the XL Motor
manifold. Use the bolts to install the XP-hf
PressureTrak module.
3. Remove the plug (126) and o-ring (125) by
removing the retaining ring (127).
3A3320D
System with System with with
Shutdown and Pressure Shutdown Pressure Pressure
Procedure. See your
Procedure
4. Remove two right side bolts (23) form the XL
motor valve.
5. Install solenoid (8) into the solenoid hole.
6. Bolt down the solenoid holding bracket (17) with
two bolts while pushing the bracket to the left to
hold the solenoid tight in the hole.
7. Insert o-ring (19) on pressure sensor (XD).
Lubricate o-ring and install into the A side (blue)
of the manifold. Torque sensor nut to 40–50
in-lb (54–67 N•m). Insert o-ring (19) on pressure
sensor (XD). Lubricate o-ring and install into the
B side (green) of the manifold. Torque sensor
nut to 40–50 in-lb (54–67 N•m).
8. Install the pressure sensor harness (XD) through
clamp (20) and secure to the frame with screw
(4) and nut (5).
9. Remove screws (9) to slide out module (6).
10. Connect the battery to the battery terminals.
11. Slide the module (XA) into the channel of the
housing (XB) and secure with two screws (9).
Installation
11