Simple Mode - Operation - Lopi Deerfield Manual

26

Simple Mode - Operation

When heating is needed follow the steps below:

Turn the stove on. The On/Off button is
located in the lower left‐hand corner of the
display. Press the On/Off Button to start and
stop the heater.
-
The On/Off Button will transition to GREEN.
Setting the Target Temperature (simple mode only)
Internal (Built-In) Thermostat (available only when thermostat source is set to "Internal".
NOTE: Internal or external thermostat is set by the installer in the "Dealer Service Mode".
Press the Thermostat Button on the control panel. When the digital display shows the Heat Setting Slider, the target
temperature is ready to be programmed. Use the Heat Setting Slider to adjust the target temperature.
External Thermostat
External thermostats are available to control the pellet heater (wired, programmable, etc.). Refer to the instructions
included with the external thermostat to set the target temperature.
NOTE: Internal or external thermostat is set by the installer in the "Dealer Service Mode".
To Adjust the Heat Output
Use the Heat Setting slider to adjust heat output.
NOTE: Heat output may vary depending upon which
TSTAT program you are in. For details see "Thermostat
Programs" on page 33.
TIP: If the stove turns on and off repeatedly, you may wish to turn the heat output to a lower setting. This
provides a more consistent heat output, eliminating the need for the thermostat to turn the heater on and
© Travis Industries
Operation
12/18/20 - 1550
Heat Setting
Deerfield Stove