Operation; Safety Notice; Location Of Controls - Lopi allegiance Owner's Manual

Safety Notice

Read this entire manual (especially the "Safety Precautions" on pages 2 and 3)
before using this stove.
damage, bodily injury, or even death.

Location of Controls

On/Off Switch
Gas Control Knob
Flame Adjust Knob
Pilot Igniter
Blower Knob
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the heater off always.
Travis Industries

Operation

Failure to follow the instructions may result in property
The on/off switch and optional blower
control are located on the back of the
heater.
Gas Controls
Pilot Igniter
Gas Control Knob
This control is used to turn the main burner on and off.
This knob is used to control gas to the heater and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer directly below
the knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer to the upper left of the knob points to the position this knob is in.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly
next to the pilot, igniting the pilot flame.
This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
4041220
ON/OFF
Switch
ON
OFF
The Pilot Flame
can be found below
the back log.
Flame Adjust Knob
21
Optional
Blower
Control
9 3 5 0 8 1 2 3