BMW R 1200RS 2016 Rider's Manual page 35

Possible cause:
Wheels without TPC/RDC sen-
sors are mounted.
Retrofit wheel set with
TPC/RDC sensors.
Possible cause:
1 or 2 TPC/RDC sensors have
failed or a system fault has oc-
curred.
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Transmission error
with Tire Pressure Control
OE
(TPC/RDC)
-- -- --
" " or " " is indicated.
Possible cause:
The motorcycle has not reached
the minimum speed (
TPC/RDC sensor is not
active
min 19 mph (min 30 km/h)
(The TPC/RDC sensor does
not transmit a signal to the
motorcycle until this minimum
speed has been exceeded.)
Watch the TPC/RDC display
at higher speed. A continuous
error is only present if the gen-
eral warning light also lights up.
In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the TPC/RDC sensors.
Possible causes are radio sys-
108).
tems in the surrounding area,
which interfere with the connec-
tion between the TPC/RDC con-
trol unit and the sensors.
Observe the TPC/RDC display
in a different environment. A
continuous error is only present
if the general warning light also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Battery of tire-inflation
pressure sensor weak
with Tire Pressure Control
OE
(TPC/RDC)
shows yellow.
appears on the display.
NOTICE
This fault message is only shown
for a short time immediately fol-
lowing the Pre-Ride-Check.
3
33
z