Omron Ateg H3DT Series Manual page 18

Datenblatt
Zeitrelais H3DT
H3DT
Twin Timer
H3DT-F
• Switch between flicker-OFF or flicker-ON start mode.
• Independent ON time and OFF time settings.
• Eight time ranges from 0.1 s to 1,200 h.
Ordering Information
List of Models
Operating modes
Flicker OFF start/flicker ON start
Model Structure
Model
H3DT-F
* Certification is pending for DNV GL.
Specifications
Time Ranges
Time range setting
Set time range
Scale numbers
Ratings
Power supply voltage *1
Allowable voltage fluctuation range
Power reset
Reset voltage
Power consumption
Rated Insulation Voltage
Control output
Ambient operating temperature
Storage temperature
Surrounding air operating humidity
*1. When using a 24-VDC power supply voltage, there will be an inrush current of approximately 0.5 A. Allow for this inrush current when turning
ON and OFF the power supply to the Timer with device with a solid-state output, such as a sensor.
*2. DC ripple: 20% max.
Erstellt am 09.10.2020 um 23:38 Uhr | Alle Angaben ohne Gewähr, Irrtümer und Änderungen vorbehalten!
|
ATEG Automation GmbH Intzestraße 50
Supply voltage
24 to 240 VAC/DC
Operating modes Terminal block
Flicker OFF start/flicker ON start 6 terminals
0.1 s 1 s 10 s
0.1 to 1.2 s 1 to 12 s 10 to 120 s
24 to 240 VAC/DC, 50/60 Hz *2
85% to 110% of rated voltage
Minimum power-OFF time: 0.1 s
10% of rated voltage
H3DT-F At 240 VAC: 1.9VA max., at 240 VDC: 0.6W max., at 24 VDC: 0.3W max.
250 VAC
Contact output: 5 A at 250 VAC with resistive load (cos = 1),
5 A at 30 VDC with resistive load,
0.15 A max. at 125 VDC with resistive load,
0.1 A max. at 125 VDC with L/R of 7 ms.
The minimum applicable load is 10 mA at 5 VDC (P reference value).
Contact materials : Ag-alloy
(Recommended fuse: BLN5 (Littelfuse) or 0216005MXEP)
20 to 60C (with no icing)
40 to 70C (with no icing)
25% to 85%
|
42859 Remscheid
For the most recent information on models that have been
certified for safety standards, refer to your OMRON website.
Control output
Contact output: SPDT Model
Output type Mounting method
Relay, SPDT DIN Track mounting
1 min 10 min
1 to 12 min 10 to 120 min 1 to 12 h
12
| |
Germany Tel.: +49 (0)2191 / 591457-0
*
LR
* CSA conformance evaluation by UL.
H3DT-F
H3DK-F
Safety standards
cULus
(UL508 CSA C22.2 No. 14)
CCC
LR
DNV GL *
EN 61812-1
IEC 60664-1 4 kV/2
1 h 10 h 100 h
10 to 120 h 100 to 1,200 h
17
| | www.ateg.de
info@ateg.de
Seite 18 von 37