Adjusting Retaining Clamp And Knee Cushions - Invacare Dragon Vertic User Manual

Invacare® Dragon Vertic
• 13 mm socket wrench
• 13 mm torque wrench
1. Loosen nut (1) of release lever.
2. Adjust ever to desired position.
3. Re-tighten nut to 15 Nm.

5.5.3 Adjusting retaining clamp and knee cushions

Setting depth of retaining clamp
• 5 mm Allen key
What should be observed when adjusting the
distance of the knee cushion to the shin?
If the distance of the knee cushion to the shin is too
small, great pressure is asserted on the legs when
standing up. If the distance is too large, the user can
"collapse" whilst standing up.
32
The holes in the inner and outer tubes are spaced differently.
The many possible combinations of holes provide the ability
to finely adjust the retaining clamp.
1. Loosen Allen screws (1) and remove.
2. Choose hole pattern combination inner tube/outer tube
to set desired knee clamp position.
3. Re-insert screws and tighten.
Adjusting height of knee cushions
• Torx wrench T25
CAUTION!
Risk of injury
– The knee pads should not press directly on
the knees. The upper edge of the knee pads
should be positioned just below the upper end
of the shin bone.
1451170-L